Hey! Here’s the complete manual installation process step-by-step. First, manual installation begins with digging shallow holes at the locations of future supports, which were pre-marked with special pegs during foundation layout – holes are usually made with a shovel or special auger. Second, insert the bladed supports into the prepared holes. Third, gradually tighten them clockwise, screwing them into the ground. This procedure typically requires three people: two of them screw in the pile from different directions using the lever rods, while the third constantly checks the verticality of the installation using a level or plumb line. Fourth, continue screwing the pile until it is fully installed and reaches the dense soil layers – don’t stop prematurely. Fifth, once the procedure is complete, check the verticality of the structure again using a special tool like a metal tape measure, plumb line, or level for final verification. The pile must be completely vertical throughout the process – any deviation compromises the foundation. For the tools, you’ll need metal rods threaded through machined holes in the pile top to serve as levers, and ideally a mounting head that attaches to the pile with a pin and has two handles for easier screwing. Full instructions at https://choosing-piles-for-construction.blogspot.com/2025/03/step-by-step-instructions-for.html Follow each step carefully and don’t rush – precision is more important than speed.
